How to roof a tile

How to roof a tile

If you need practical and very easy roof with original impressive drawing, choose a flexible tile. It is not subject to burning, differences of temperatures and corrosion. Besides, it can be mounted independently.

It is required to you

- board flooring;
- sheets of a tile;
- roofing nails;
- metal eaves;
- bituminous glue.

The sponsor of placement P&G Articles on the subject "How to Roof a Tile" How to calculate a mansard roof How to count a roof bias How to write the application on repair of a roof

Instruction

1
Laying of a flexible tile will require the firm equal basis. For its creation roof a board flooring or plywood. Cover the basis the lining carpet allowing to close all cracks and joints through which water can get.

2
At first cover one it is sloping roofs. Roll a roll lengthways, beginning from below. Then level on an edge, having cut off surplus of a carpet at the edges. Fix a cover special nails which hat has diameter of 8 mm. Otherwise, the nail will pass material through, having damaged it. Covering the second slope of a roof, stack the following leaf of a lining carpet with an overlap. Glue edges bituminous glue. Thickness of the put layer of glue should not exceed 1 mm that the covering was not dissolved.

3
For protection against dampness of end faces use metal eaves. Be attentive at their installation as for lateral and lower edges different eaves are necessary. That water did not flow by pediment part of a roof, for lateral edges mount eaves with the special side serving for a water slope down.

4
When everything is ready, start laying of the tile. In different packings the shade and the invoice of a tile can differ a little. To make a difference imperceptible, mix a tile from different packings. It is not necessary to apply glue on sheets, it is necessary to remove the protective only. And here glue needs to be applied on joints. Their additional gluing will protect from moisture penetration. After putting glue in these parts, level it a scraper.

5
Start spreading a tile from bottom edge of a roof. Frame it with the ridge and eaves tile which does not have petals at the edges. Fix, driving in nails on the upper edge of a tile. Imposing the first row of a tile with petals, recede from the roof edge of 10 mm that, having stretched, the tile did not play for the roof edge.

6
Join the subsequent sheets with previous, combining the tooth which is specially provided for this purpose at an end face. Stack sheets so that petals of the top closed fastenings and joints of the lower. Cover top of a roof with a tile without petals. Divide a leaf into some parts and fix nails with an overlap, like fish scales.