How to put a felling

How to put a felling

People who are engaged in folding of a felling, will surely tell that business this very difficult, but after all the feasible. Construction of the house from a felling manages much cheaper, than construction of the brick house.

The sponsor of placement P&G Articles on the subject "How to Put a Felling" How to cut a felling in a bowl How to cut a felling in a paw How to make a felling of a bar

Instruction

1

For a start surely decide on material. It is not necessary to save on it, after all the house has to serve you some tens years. Such breeds as a fir-tree and a pine are suitable for this type of construction more. These trees contain necessary amount of pitch. It means that the felling will not crack and will be steady against moisture. It is also possible to use an aspen. This tree too is not afraid of water. Extremely it is not recommended to use a birch. The matter is that it begins decaying quickly and it is necessary to be engaged in its continuous processing.

2

It is best of all to prepare logs since fall. At this time it is also necessary to be engaged in their preparation for construction. Remove bark, but not up to the end. End faces should not crack. At the top and lower ends of a log leave bark 10 centimeters wide strips. For reliability it is best of all to cover them with dense limy solution and to leave for 3-5 months for drying.

3

Further we pass to construction. Any felling consists of wreaths. Their quantity depends on house height. The wreath represents four logs. They form a horizontal number of a felling. The first wreath of a felling call okladny. It is intended to strengthen the lower binding, and also to protect it from rotting. The second wreath – the lower binding into which logs crash, pull together it and bear a floor. The thickest logs need to be squared on two edgings, i.e. to make flat from two parties. After that it is possible to stack on okladny a wreath.

4

Start putting a felling. Stack two logs in parallel horizontally each other. After that across at right angle it is necessary to put the two second on them logs. Only after laying it is possible to carry out angular connections. Consider, any log will increase in the diameter from a trunk, adjacent to a root of part, to top. During laying of logs it is necessary to alternate koml and tops. For nagily it is better to do nests more than their length on 1,5-2 cm because of the subsequent shrinkage of wood.